ECS 965PLT-A - Page 40

34
Using BIOS
f
ACPI Table/Features Control (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
This item is valid only for
WIN2K and WINXP. Also, a
fresh install of the OS must
occur when APIC Mode is
desired. Test the IO ACPI by
setting item to Enable. The
APIC Table will then be pointed
to by the RSDT, the Local APIC
will be initialized, and the
Advanced
APIC - IO APIC Mode (Enabled)
This item allows you to enable or disable APIC (Advanced Programmable Interrupt Con-
troller) which can provide symmetric multiprocessing (SMP) for systems, allowing support
for up to 60 processors.
f
Performance Support (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Advanced
Press <Esc> to return to the Advanced Features page.
InsydeH20 Setup Utility
Select Boot Device
Select Screen
Select Item
Select f SubMenu
Setup Defaults
Save and Exit
Exit
+ -
< >
qr
Enter
F9 =
F10 =
ESC =
InsydeH20 Setup Utility
Select Boot Device
Select Screen
Select Item
Select f SubMenu
Setup Defaults
Save and Exit
Exit
+ -
< >
qr
Enter
F9 =
F10 =
ESC =
ACPI Table/Features Control
APIC - IO APIC Mode: <Enabled>
Performance Support
PCIE CLK Synchronize <Enabled>
Spread Spectrum <Enabled>
CPU Clock <266>
Adjust Extra CPU Voltage <Normal>
Adjust Extra DIMM Voltage <Normal>
Adjust Extra NB Vcore <Normal>