16
Using BIOS
Press <Esc> to return to the main menu setting page.
ACPI Suspend Type (S3)
Use this item to define how your system suspends. In the default, S3, the suspend type
is suspend to RAM, i.e., the system shuts down with the exception of a refresh
currentto the system memory.
Power Management Setup
This page sets up some parameters for system power management operation.
Select the ACPI
state used for Sys-
tem Suspend.
CMOS Setup Utility - Copyright (C) 1985-2010, American Megatrends, Inc.
Power Management Setup
Help Item
ACPI Suspend Type S3
PWRON After PWR-Fail Power Off
EUP Support Enabled
Resume By PCI-E/Lan PME Disabled
Resume By USB (S3) Disabled
Resume On RTC Alarm Disabled
: Move F10: Save and Exit
+/-/: Value
Enter : Select
F9: Optimized Defaults
F1:General Help
mnlk
ESC:Exit Wothout Saving
PWRON After PWR-Fail (Power Off)
This item enables your computer to automatically restart or return to its operating
status.
Resume By PCI/PCI-E/Lan PME (Disabled)
These items specify whether the system will be awakened from power saving modes
when activity or input signal of the specified hardware peripheral or component is
detected.
EUP Support (Enabled)
This item enables your computer to support energy star.
Resume by USB (S3) (Disabled)
This item allows you to enable/disable the USB device wakeup function from S3/S4
mode.
Resume on RTC Alarm (Disabled)
The system can be turned off with a software command. If you enable this item, the
system can automatically resume at a fixed time based on the system RTC (realtime
clock). Use the items below this one to set the date and time of the wake-up alarm.
You must use an ATX power supply in order to use this feature.
To Next Page
Loading...
Need help?
General
