33
Using BIOS
1st/2nd/3rd Boot Device (Hard Drive/CD/DVD/Removable Drive)
Use this item to determine the device order the computer used to look for an
operating system to load at start-up time. The devices showed here will be different
depending on the exact devices installed on your motherboard.
APIC Mode (Enabled)
This item allows you to enable or disable the APIC (Advanced Programmable Inter-
rupt Controller) mode. APIC provides symmetric multi-processing (SMP) for sys-
tems, allowing support for up to 60 processors.
Boot Up Numlock Status (On)
This item defines if the keyboard Num Lock key is active when your system is
started.
Quick Power on Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up faster
.
You might like to enable this item after you are confident that your system
hardware is operating smoothly.
fHard Disk Drives (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Hard Disk Drives
1st Drive MAXTOR STM3250310AS
2nd Drive Flash Disk
Help Item
Specifies the boot
sequence from the
available devices.
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
Hard Disk Drives
Press <Esc> to return to the Advanced Setup page.
mnlk
: Move
F10: Save ESC: Exit
Enter : Select
+/-/: Value
F9: Optimized Defaults
F1: General Help
Intel (R) HT Technology (Enabled)
This item enables or disables Intel HT Technology support.
To Next Page
Loading...
Need help?
General
