ECTIVE BB & SBB 25
Installation
• Install the Battery Booster near the board supply battery I (for short
charging cables) on a clean, even and hard mounting surface. Make
sure the device is protected from water, humidity, corrosion and
aggressive battery gases. The unit can be installed in any position.
• During operation, the device‘s fan will cool the Battery Booster.
For efficient cooling, make sure that there is at least 10cm of clear
space in front of the vent.
• Choose the appropriate cable specifications, length and fuse
specifications for installation.
• Caution! A reverse connection of the battery will cause serious
damage to the equipment!
• When using a Temperature Sensor, make sure that it is not affected
by any external sources of heat.
Please note the following diagrams to ensure the correct connections for
your device.
ECTIVE BB30
To Next Page
Loading...
