What to do if my ECX Motorized Toy Car has poor range?
If your ECX Motorized Toy Car has a poor range, the transmitter batteries may be low, so try replacing or recharging them. Another cause could be a damaged receiver antenna, which you should check, repair, or replace if necessary.
What to do if the system of my ECX Motorized Toy Car will not connect?
If the system of your ECX Motorized Toy Car won't connect, the transmitter and receiver might be too close to each other; move the transmitter 3.3–9.8ft (1–3m) from the receiver. Alternatively, they could be too close to large metal objects, so move away from vehicles or similar items. Ensure the throttle trim on the transmitter is set to zero, then turn off and on both the transmitter and vehicle. Lastly, the receiver might have accidentally entered bind mode, so rebind the transmitter and receiver.
What to do if the receiver of my ECX Motorized Toy Car quits responding during operation?
If the receiver of your ECX Motorized Toy Car stops responding during operation, it could be due to low battery voltage. Completely recharge the battery. Another possibility is loose or damaged wires or connectors between the battery and receiver. Inspect these wires and connections, and repair or replace them as needed.
Why does my ECX Motorized Toy Car have sluggish action?
If your ECX Motorized Toy Car is moving sluggishly, the motor might be dirty, requiring a check and cleaning. There could also be a bind in the drivetrain, which needs cleaning and adjustment. Finally, the vehicle battery might not be charged, so replace or recharge it.
What to do if the receiver of my ECX Motorized Toy Car goes into failsafe mode a short distance away from the transmitter?
If the receiver of your ECX Motorized Toy Car enters failsafe mode close to the transmitter, check the receiver antenna for cuts or damage and ensure the antenna is correctly positioned in the antenna tube.
Why are the controls reversed on my ECX Motorized Toy Car?
If the controls on your ECX Motorized Toy Car are reversed, the ST. REV or TH. REV switch position is likely incorrect. Change the switch position.
Why does my ECX Motorized Toy Car move without input?
If your ECX Motorized Toy Car moves forward or backward without your input, the throttle trim on the transmitter might not be centered. Adjust the throttle trim on the transmitter to the neutral point.
How to adjust steering trim on my ECX Motorized Toy Car?
If your ECX Motorized Toy Car doesn't drive straight, the steering trim on the transmitter might not be centered. Adjust the steering trim on the transmitter so the vehicle drives straight.
Why is there a clicking noise in the transmission area of my ECX Motorized Toy Car?
If you hear a clicking noise in the transmission area of your ECX Motorized Toy Car, there might be dirt or rocks in the spur gear. Remove the gear cover and inspect it; replace the gear if necessary. Alternatively, the motor might have moved away from the spur gear, so reset the gear mesh.
Details the water-resistant features and provides precautions for operating in wet environments.
Information on ESC programming, configuration, and battery type settings.
General| Brand | ECX |
|---|---|
| Model | Circuit series |
| Category | Motorized Toy Car |
| Language | English |
To Next Page
