To Next PageTo Next PageWhy does my ECX Toy have a short run time?
If you are experiencing short run time with your ECX Toy, it could be due to damaged or low voltage vehicle batteries. Try charging the vehicle battery pack. Alternatively, the motor might be dirty or the brushes worn. In this case, you should check, clean, or replace the motor.
What to do if my ECX Toy doesn't operate?
If your ECX Toy doesn't operate, first, ensure the transmitter is powered on. Next, check that the ESC is also powered on. Replace or recharge low transmitter batteries. Finally, charge or replace the vehicle battery pack if the AA batteries have low voltage.
What to do if my ECX Toy has sluggish action?
If your ECX Toy has sluggish action, it might be due to a dirty motor or worn brushes, so check, clean, or replace the motor. Another cause could be a bind in the drivetrain. To resolve this, clean and adjust the gear mesh between the spur and pinion gears. Also, ensure the vehicle batteries have sufficient voltage by charging the vehicle battery pack.
How to fix reversed controls on my ECX Toy?
If the controls on your ECX Toy are reversed, the ST. REV or TH. REV switch position on the transmitter might be the cause. Change the switch position on the transmitter to correct this.
Why does my ECX Toy have poor range?
If your ECX Toy has poor range, first, replace or recharge the transmitter batteries. Also, check and tighten the transmitter antenna if it’s damaged or loose. Finally, inspect the receiver antenna for damage and repair or replace it as necessary.
General| Product type | Car |
|---|---|
| Battery capacity | 1800 mAh |
| Battery technology | Nickel-Metal Hydride (NiMH) |
| Number of battery cells | 6 |
Weight and Dimensions| Width | 295 mm |
|---|---|
| Weight | 2300 g |
Specifies the minimum age for operating this product.
Important guidelines for operating the vehicle in wet conditions.
Procedures for maintaining the vehicle after wet operation.
Critical safety warnings and procedures for charging batteries.
Safety guidelines for handling and installing transmitter batteries.
Guidance on fitting the vehicle's body after setup.
Tips for maintaining the motor's longevity and performance.
How to adjust the vehicle's ride height for handling.
Process for pairing the transmitter and receiver.
Procedure for submitting the product for inspection or service.
Guidelines for proper disposal of electronic waste in the EU.
