www.edelbrock.com
Page 6 of 17
Programming the Nitrous Starting Percentage
Press and release the FUNCTION switch until the message “Starting Percentage” appears on the display.
After the function message has scrolled across the display, the current nitrous starting percentage setting will appear
on the display.
To adjust the nitrous starting percentage value, press the desired digit button and the value of that digit will
increment. The digit will roll over to 0 and begin counting up again if the user continues to release and press the digit
button. If the .1 digit button is pressed, the starting percentage will go to 100%, pressing again will set the starting
percentage back to 0%. The 1. digit is ignored for this function.
To exit without saving the new value, press the FUNCTION switch and select another function.
To save the new value, press and release the ENTER switch and the display will read “SAVED” and the new
setting is now saved.
The range of nitrous starting percentage is 10% to 100% in 1% increments.
This setting will determine the amount of nitrous to be applied after the nitrous delay timer has elapsed.
Programming the Final Nitrous Percentage
NOTE - If the dual ramp feature is enabled fron the options menu, there will be a “Final Percent #2” in the
menu list. The programming method is the same as the “Final Percent #1”. Please refer to the section “Options
Menu” and “Using the Dual Ramp Feature” for more information.
Press and release the FUNCTION switch until the message “Final Percent #1” appears on the display. After
the function message has scrolled across the display, the current final nitrous percentage setting will appear on the
display.
To adjust the final nitrous percentage value, press the desired digit button and the value of that digit will
increment. The digit will roll over to 0 and begin counting up again if the user continues to release and press the digit
button. If the .1 digit button is pressed, the final percentage will go to 100%, pressing again will set the starting
percentage back to 0%. The 1. digit is ignored for this function.
To exit without saving the new value, press the FUNCTION switch and select another function.
To save the new value, press and release the ENTER switch and the display will read “SAVED” and the new
setting is now saved.
The range of the nitrous final percentage is 10% to 100% in 1% increments.
This setting will determine the amount of nitrous to be applied at the end of the nitrous power ramp time.
©2009 Edelbrock Corporation
Part #71900
Brochure #63-0473
Rev. 05/09 - AJ/mc
To Next Page
Loading...
