Edelbrock 1465 User Manual

®
Off-Road Needle & Seat Assembly
for Performer Series Carburetors
Catalog # 1465
Installation Instructions
) Please study these instructions carefully before installing your Off-Road needle & seat assembly. If you have any
questions or problems, do not hesitate to contact our Technical Hotline at: (800) 416-8628 from 7:00 am to 5:00
pm, Monday through Friday, Pacific Standard Time or e-mail us at: edelbrock@edelbrock.com.
) Use Owner's Manual supplied with carburetor for disassembly and reassembly.
) Remove original needle and seat assembly and replace with #1465 (Figure 1). To reset float level, see Figure 2 for proper
offroad setting (7/16").
OFF-ROAD FLOAT LEVEL
With bowl cover inverted, bowl cover gasket in place, and
weight of float seating needle, there should be 7/16" between
top of each float and bowl cover gasket (at outer end). The
sides of floats should be parallel to the outer edge of the bowl
cover. To adjust, bend float lever.
CAUTION! DO NOT PRESS NEEDLE INTO SEAT WHEN
ADJUSTING FLOAT LEVEL.
Brochure #63-0162
© 2002 Edelbrock Corporation
Rev. 12/02
Needle and Seat assembly
BEND HERE
MEASURE AT
OUTSIDE END
7/16"
Figure 1
Figure 2

Edelbrock 1465 Specifications

General

Product Type	Carburetor
Part Number	1465
Model	Performer Series
Series	Performer
Product Line	Edelbrock
Material	Aluminum
Engine Type	Gasoline
Intake Manifold Type	Square Bore
Carburetor Flange	Square Bore
CFM	600
Number of Barrels	4
Fuel	Gasoline
Choke Type	Electric
EGR Provision	No
Fuel Injection Compatible	No
Number of Ports	4
Engine Family Compatibility	Ford
Port Style	Standard
Height	3.25 inches

Summary

Edelbrock Off-Road Needle & Seat Assembly Installation

Needle and Seat Assembly Diagram

Diagram illustrating the needle and seat assembly components for installation.

Off-Road Float Level Adjustment

Instructions for setting the off-road float level to 7/16", including adjustment methods and a caution.