If you detect a problem
when using your was-
hing machine, you may
be able to solve it after
consulting the following
troubleshooting tips.
If you cannot find the
solution, disconnect the
machine and contact
the TECHNICAL SUP-
PORT SERVICE
• Why doesn’t the washing machine start working?
Perhaps
– There is no voltage in the electricity mains.
– The fuses of the electrical fittings are blown.
– The washing machine is not connected to the electricity
mains.
– You didn’t press the on/off button(this button’s light
should be on)
– The programme selector dial is not out.
– The door of the washing machine isn’t closed properly.
When this is detected, the displays that show “pre-
wash” or “end” flash and F04 appears on the display of
the washing machine. Then you should check if the door
is open and close it properly.
• Why does the washing machine vibrate or make too much noise?
Perhaps:
– The internal fastening screws were not removed.
– The washing machine is not level.
Please do not open the
machine under any
circumstances.There is
no fuse or similar com-
ponent inside that may
be replaced by the user.
IMPORTANT
WASHING MACHINE
SAFETY AND TROUBLESHOOTING
To Next Page
Loading...
