Handbook
ECW-5210-L Enterprise Access Point ENGLISH
2. Connect the ECW5210-L to your network device.
Connect one end of the Ethernet cable to the Uplink port of ECW5210-L and the other end of the cable to a
switch, a router, or a hub. ECW5210-L is then connected to your existing wired LAN network.
3. Power on the ECW5210-L.
There are two ways to supply power over to ECW5210-L.
- ECW5210-L Uplink port is capable of receiving DC currents. Connect an IEEE 802.3at-compliant PSE
device (e.g. a PoE-switch) to the Uplink port of ECW5210-L with the Ethernet cable.
- Connect a 12V/2.5A adaptor (optional) to the DC power jack. If needed, use the DC extension plug
included.
Now, the Hardware Installation is complete.
Using a different power adapter may damage this system.
To verify the wired connection between ECW5210-L and you switch / router / hub, please also check
the LED status indicator of the respective network devices.
To Next Page
Loading...
Need help?
General
