Part
Two
Operation
Without Guard/Depth Gauge Installed
After proper set-up and running-in, your Cutters Edge
Ventilation Saw will be available for service. In the field,
you should follow certain procedures for the use of your
saw to insure safe and efficient operation.
The basic rules for safe operation of your Cutters Edge
Ventilation Saw include:
1)
Wear full turn-outs with gloves, face shield or
goggles.
2) Keep a firm grip on the saw.
3) Avoid cutting across your body.
4) Cut with full RPMs.
5) Avoid the bar's kickback zone.
6) Do not attempt to operate saw without comple-
tion of your department's training for the use of
a power tool.
WARM UP
As another safety feature, your Cutters Edge Ventilation
Saw is equipped with One-Step Starting. To take advan-
tage of One-Step Starting, the saw must be warmed up
prior to going on the roof.
To warm up the saw after you have reached the scene of
your operation, use the following starting procedure:
1) Pull out the choke.
NOTE
Remember not to touch the throttle while starting
the saw.
2) Step on the back handle and grip the top handle
firmly.
3) Pull the starter handle upward sharply a few
times until the engine catches.
4) Push the choke in and pull the starter handle
again to start the engine.
5) Squeeze the trigger quickly once to set the idle.
Allow the saw to warm up, then touch the
momentary contact switch to shut it off. It is now
ready for use.
Fig. 16. The TS-10 Sling.
THE TS-10 SLING
17
Carry the saw up ladders by attaching the tool sling (Fig.
16). Loop the hook on the end of the sling around the top
handle and clip it to the D-ring on the sling. Attach the other
end of the sling to the back handle in the same manner.
Once on the roof, remove the sling and place it in your
pocket or out of your way.
WARNING
Never operate the Cutters Edge Ventilation Saw
with the sling attached.
IMPORTANT
Always operate the saw with a minimum of two
people on the roof for safety. One should operate
the saw and the other act as backup and as eyes
and ears for the operator.
Always wear full protective gear, along with a face
shield or
goggles.
Sound the roof for the safest operator position.
Select and prepare an alternate escape route.
Position yourself properly and prepare to cut.
To Next Page
Loading...
General