To Next PageTo Next PageWhat to do if Control box cooling fan will not run in Edge EDGE-3260?
If the control box cooling fan in your Edge Oven isn't running, check for 120VAC going to the cooling fan. If there is power, you should replace the fan. If there's no power, check for 120VAC at terminal #4 on relay K1.
Why Edge Oven fans will not turn off?
The Main Motor and Cooling Fan in your Edge Oven are designed to continue running as part of a cool-down operation until the internal temperature reaches 223°F/107°C.
Why Edge Industrial Equipment oven does not heat?
If your Edge Industrial Equipment oven isn't heating, start by verifying that fuel is present and purge the fuel line of any air. Next, check if the protection thermostat has tripped; you can reset it under the main motor cover. During operation, monitor the oven temperature and consider replacing the thermocouple if it seems to be failing. You may also need to follow the diagnostic tables.
Why control box cooling fan will not run on Edge Industrial Equipment?
If the cooling fan in the control box of your Edge Industrial Equipment isn't running, check for 120VAC going to the fan. If there is power, the fan likely needs to be replaced. If there's no power at the fan, check for 120VAC at terminal #4 on relay K1.
Why oven fans will not turn off on Edge Industrial Equipment?
The main motor and cooling fan on your Edge Industrial Equipment will continue to run until the oven cools down to 223°F/107°C. This is part of the cool down operation.
What to do if Edge Industrial Equipment has conveyor belt jam?
If your Edge Industrial Equipment conveyor belt is jammed, check for any objects obstructing the belt. Clear the belt, put the oven into cooldown mode, and then power it back on.
General