EdgeStar BBR900BL - Wires Shelves; Lamp

- 12 -
3.
DISASSEMB
LY

GLASS SHELVES
(Models：CBR901SG，CBR1501SG, CBR1501SLD,
CBR1501SSOD)
 Open
the door completely.
 If necessary, make sure you remove all the
contents sitting on the shelf.
 Remove both of the plastic notches with a
screwdriver.
 Continue to pull the shelf forward until it is
completely removed from the inner
compartment. (Figure 6)

Figure 6
 WIRES SHELVES
TYP A : (Models：CWR181SZ，CWR301SZ，
BWR300BL，BBR900BL，CWR531SZ)
 Open
the door completely.
 If necessary, make sure you remove all the
contents sitting on the shelf.
 Pull the shelf forward until the notch aligns with
the plastic post on each side of the shelf track.
 Lift the shelf until both notches pass through the
posts.
 Continue to pull the shelf forward until it is
completely removed from the inner compartment.
(Figure 7)
Figure 7
TYP B : (Models：CWR70SZ)
 Open
the door completely.
 Make sure the shelf is pushed back completely
(towards the rear wall).
 If necessary, make sure you remove all the
contents sitting on the shelf.
 Identify the protective stoppers located on the
right and left sides of the back of each shelf.
 Lift either the left or right side of the shelf
creating a 45° angle from its original position.
Make sure not to lift either side of the shelf too
hard as it may come in contact with the inner
wall mount.
 Pull the shelf forward until it is completely
removed from the inner compartment. Set
aside safely. (Figure 8)
Figure 8
3-3 LAMP
(Models：CBR901SG, CWR301SZ, BWR300BL,
BBR900BL, CBR1501SG, CWR531SZ, CBR1501SLD,
CBR1501SSOD, CWR1661SZ, CWR1211SZ)
1.
Loosen four screws. (figure 9)
screws
Figure 9
2.
Loosen the display PCB board fixer and take out the PCB
board. (figure 10)
Figure 10