EdgeStar BBR900BL - 3-6 SENSOR & FAN

- 24 -
3.
DISASSEMB
LY
2. The power board & transformer are like below. (figure 98)
Figure 98
(Models：CWR5631FD，CWB2886FD)
1. Loosen three screws. (figure 99)
Figure 99
2. The power board & transformer are like below.
(figure 100)
Figure 100
( Models：RP400MED)
1. Loosen three screws. (figure 101)
Figure 101
2. The power board & transformer are like below.
(figure 102)
Figure 102
3-6 SENSOR & FAN
(Models：CWR70SZ)
1、 Remove screws from the wiring trough , take out the wiring
trough. You can replace the sensor .(figure 103)
Figure 103