EasyManua.ls Logo

EdgeStar CBR902SG - Removing and Installing Decorative Plugs

EdgeStar CBR902SG
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
5. Install the lower hinge and bushing on the bottom left support bracket.
6. Carefully insert the door into the upper right corner hinge, then slide the door on top
of the lower hinge and secure the door by installing the lower screws.
Removing and Installing Decorative Plugs
Follow the instructions below to remove the decorative plugs from the door.
1. Open the door and carefully pull the door gasket from the top left corner until you have
exposed the two holes which correspond with the decorative plugs.
2. Insert a Flathead screwdriver through the gasket side of the door into the decorative plug
slot. You may need to use a flashlight to help guide you through this process.
Important: Before you begin, unplug the refrigerator.

Related product manuals