EdgeStar CWR1211SZ - Power Board & Transformer

- 21 -
3.
DISASSEMB
LY
5、Tear down the film(figure 78)
Figure 78
6、Pull open the display board support bracket.(figure 79)
Figure 79
7、Remove the PCB board fixer and take it out.(figure 80)
Figure 80
8、The display board is like below. (figure 81)
Figure 81
3-5 POWER BOARD & TRANSFORMER
(Models：CWR70SZ)
1. Put down the unit like the image below . (figure 82)
Figure 82
2、Open the electrical box cover (figure 83)
Figure 83
3. The power board & transformer are like below. (figure 84)
Figure 84
(Models：CWR181SZ)
1、Remove the screws from the electrical box near the
compressor (figure 85)
Figure 85