EdgeStar CWR1211SZ - Compressor Ptc Starter & Overload Protector

- 28 -
3.
DISASSEMB
LY
(Models：CWR5631FD，CWB2886FD)
1. Loosen screws. Pull out the rear air duct cover.
(figure 1 2 2 )
Carbon Filter
fan
sensor
screw
Figure 122
2.
Loosen 1 screw. You can replace the sensor ,
heat
er
&
fan.(figure 123)
wire housing
screw
heater
evaporator
Figure 123
( Models：RP400MED)
1. Loosen screws. Pull out the rear air duct cover.
(figure 1 2 4 )
screw
fan
sensor
Figure 124
2.
Loosen 1 screw. You can replace the sensor ,
heat
er
&
fan.(figure 125)
wire housing
screw
evaporator
defrost
sensor
Figure 125
3-7 COMPRESSOR PTC STARTER & OVERLOAD
PROTECTOR
(Models：CWR181SZ)
1.
Remove the clamp that is used to fix the compressor
junction box., take out the box. (figure 126)
Figure 126
2. Dismantle the compressor PTC starter and overload
protector. (figure 127)
Figure 127