EdgeStar CWR1211SZ - Page 31

- 31 -
3.
DISASSEMB
LY
2. Remove the compressor junction box. (figure 140)
Figure 140
3. Dismantle the compressor PTC starter and overload
protector. (figure 141)
Figure 141
4. The compressor PTC starter and overload protector is
like below. (figure 142)
Figure 142
(Models：CWR1661SZ)
1. Open the box near compressor, take out the box.(figure
143)
Figure 143
2、 Remove the compressor junction box. (figure 144)
Figure 144
3.. Dismantle the compressor PTC starter and overload
protector. (figure 145)
Figure 145