EasyManua.ls Logo

EdgeStar CWR460DZ - Page 10

EdgeStar CWR460DZ
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
15. The defrost senser is located in the following position.
16. The PTC heater is located in the following position.
17. Remove the fixing screws then you can replace the
PTC heater.
18. For details of how to replace the upper zone sensor
& lower zone sensor,please follow these instructions.
A. Disconnect all the wires the pull out the rear air duct
cover. Press the nails fixing the senser cover use
screwdriver at the back of the rear air duct cover.
B. Take away the sensor cover from the rear air duct
cover.
C. Take away the sensor from sensor cover.
D. Remove the nails from sensor cover & replace the
new sensor.
E. Press the nails at the ends of the sensor cover use
screwdriver.

Other manuals for EdgeStar CWR460DZ

Related product manuals