11
7.4 REPLACING THE CONDENSER FAN MOTOR ,COMPRESSOR PTC STARTER AND OVERLOAD
PROTECTOR
1. Remove the two screws that are used to fix the
condenser fan motor with the compressor base.
2. Remove the three screws that are used to fix the
junction box with the cabinet.
3. Disconnect the condenser fan motor cables on the
power PCB then you can replace the condenser fan
motor.
4. Remove the clamp that is used to fix the junction
box of compressor .
5. Remove the junction box cover.
6. Disconnect the compressor
PTC starter and overload
protector
cable with compressor. Now you can
replace the compressor PTC starter and overload
protector
.
To Next Page
Loading...
