9
7. Disconnect the wires then you can replace the
evaporator fan motor and lower zone fan motor.
8. Remove two screws that are used to fix the bottom
plate of middle partition with the cabinet.
9. Remove two screws that are used to fix the bottom
plate of middle partition with the rear air duct cover.
10. Remove one screw that are used to fix the light
cover with the bottom plate of middle partition.
11. Disconnect the housing from the LED light
assembly.In this step,
If it’s necessary, you can
replace the LED light assembly.
12. Remove the the bottom plate of middle partition.
13. remove the screws that are used to fix the rear air
duct cover with the cabinet.
14. The evaporator is located in the following position.
To Next Page
Loading...
