EdgeStar CWR5631FD - Troubleshooting

- 15 -
3.
DISASSEMB
LY
2. T
ake out the LED light connector. Remove the
screws from LED light.
(figure 2 8 )
Figure 28
3. The LED light is like below. (figure 29)
Figure 29
3-4 DISPLAY BOARD & CONTROL BOARD
(Models：CBR901SG, CWR301SZ, BWR300BL,
BBR900BL, CBR1501SG, CWR531SZ, CWR1661SZ,
CWR1211SZ)
1. Loosen four screws. (figure 30 )
2. Pull out the electrical box.
Figure 30
Screw
3.
Unplug all cable connectors. (figure 31)
4. Press the plastic nail supporting the control board with
forefinger and thumb.
Figure 31
5. The control board is like below. (figure 32)
Figure 32
6. Disassemble the display board. (figure 33)
Figure 33
7. The display board is like below. (figure 34)
Figure 34
(Models：CBR1501SLD, CBR1501SSOD)
1. Loosen four screws. (figure 35)
2. Pull out the electrical box.
Figure 35
Screw