EdgeStar CWR5631FD - Page 20

- 20 -
3.
DISASSEMB
LY
3、Tear down the film。(figure 70)
Figure 70
4、Pull open the display board support bracket.(figure 71)
Figure 71
7、Remove the PCB board fixer and take it out.(figure 72)
Figure 72
8、The display board is like below. (figure 73)
Figure 73
( Models：RP400MED)
1. Remove four screws from the electrical box and take it
out.(figure 74)
Figure 74
2、Remove all the connector from PCB board. Remove four
screws from the PCB board and take it out.(figure 75)
Figure 75
3. The control board is like below. (figure 76)
Figure 76
4. Remove all the connector from the PCB board.(figure 77)
Figure 77