EdgeStar CWR5631FD - Page 29

- 29 -
3.
DISASSEMB
LY
3. The compressor PTC starter and overload protector is
like below. (figure 128)
Figure 128
(Models：CBR901SG, CWR301SZ, BWR300BL, BBR900BL)
1.
Remove the clamp that is used to fix the compressor
junction box., take out the box. (figure 129)
Figure 129
2. Dismantle the compressor PTC starter and overload
protector. (figure 130)
Figure 130
3. The compressor PTC starter and overload protector is
like below. (figure 131)
Figure 131
(Models：CWR361FD, CBR1501SG, CWR531SZ)
1. Loosen one screw. (figure 132)
Figure 132
2. Remove the compressor junction box. (figure 133)
Figure 133