EDGETEC SYSTEMS PTY LTD Part # 9-2100 SEP2015 www.edgetec.net
TriFlo Models and Operation Guide
Auto-Heat: The “Auto-Heat” TriFlo will help maintain your spa bath water
temperature during your spa by heat transfer. This pump is activated by the air
button installed on your bath.
Xtra-Heat: The “Xtra-Heat” TriFlo has the integral flat plate 700watt Stainless Steel
heater built into the pump, this will maintain your spa bath water temperature even
in the largest spa baths. This pump is activated by the air button installed on your
bath.
EEZI-Touch: The “EEZI-Touch” TriFlo has the integral flat
plate 700watt Stainless Steel heater built into the pump
and a bath mounted touch pad which allows you to
control the pump from the baths edge.
Depressing the touch pad button will turn your pump “on
or off”. When operating the Blue Led will light up.
The heating function will automatically come on once the pump has primed and
water is detected in the spa bath pump, if there is no water in the spa bath or
insufficient water in the pump the pump will automatically shut down to protect your
pump from running dry and causing potential damage to the mechanical seal.
The Green indicator light on the touch pad is showing that the communication cable
from the pump is fitted correctly and that there is power to the spa bath pump.
Sensa-Touch: The “Sensa-Touch” TriFlo has the integral flat plate 700watt Stainless
Steel heater built into the pump and a bath mounted touch pad which allows you to
control the Pump & Heater function from the baths rim.
Depressing the Pump button will turn your pump “On or Off”, if there is no water in the
spa bath or insufficient water in the pump the pump will automatically shut down to
protect your pump from running dry and causing potential damage to the
mechanical seal.
The heating function will automatically come on once the pump has primed and
water is detected in the spa bath pump.
The Red heater indicator lights will flash in sequence to
indicate that the water is now being heated. When the
water temperature has reached the setting chosen or the
bath water is at the set temperature the red lights L, M or H
will stay on depending on the setting chosen. To turn the
heating down press the heater button, each time you press
the heater button an indicator light will turn off and the set
temperature will be reduced, when all the lights are off the
heater is no longer active. To turn the heater back on, press
the heater button and the heater will come back on at the
highest setting.
The Green indicator light in the centre of the touch pad is showing that the
communication cable from the pump is fitted correctly and that there is power to the
spa bath pump.
To Next Page
Loading...
