Edgetech 2000 Series User Manual

Model2000 Series DewPrime
Dew Point Hygrometers
----------- Operating Instructions -----------
Model2000 Series-Status Report
Current Time: :XX:X X : XX
Current Date: XX:XX:XX
Temp Units: X
ABC Start Time: :XX:XX ABC
Interval: :XX:XX
Alarm 1 Temp: XXXXX.X:X
Alarm 2 Temp: X XXXX.X:X
A1ann !latch : XXX
Alarm 2 latch: XXX
Analog out: XXXX to :X:XXX
Average: XX
Baud: XXXXX
3.9 DEFAULT PROGRAMMABLE
PARAMETERS
If a fault is detected inthe parameter memory, or the
nonvolatile memory chip is replaced, the instrument will
replace all the user entered parameters with the default
parameters listed in Table 3-5.
Ta le 3-5. Default programmable parameters.
Default
FDDc:tion Parameters
Out Interval: XX
Hold: XXX
3.8 PROGRAMMABLE INPUT PARAMETER
LIMITS
Table 3-4 is a chart of the data input limits for the
programmable parameters. If data fall between these
listed ranges, the Model2000 Series will respond with a
front panel display of "OKAY."Data outside these
ranges will cause the unit to respond with the word
"ERROR" on the front panel display and an "INVALID
ENIRY" message on the RS-232 display .
Table 3-4. Programmable limits.
Limits
Function
Min '
Max Units
ABCST
ABCINT
OUTIUGH
OU T LOW
ALARM I
ALARM2
AVE
BAUD
OUTINT
08 00 (HOURS MINUTES)
12 00 (HOURS MINUTES)
+60 DEGREES C
-40 DEGREES C
>+50.0 DEGREES C
>+50.0 DEGREES C
01
2400
60
ABCST
0000
23 59
TIME (HRSIMINS)
ABCINT
0000
23 59
TIME (HRSIMINS)
OUTHIGH
±100
±100
DEGREES
OUT LOW
ALARM!
±100
>-100.0
±100
<+100.0
DEGREES
DEGREES
ALARM2
>-10 0 . 0
<+100.0
DEGREES
AVE
01
16
READINGS TO
AVERAGE
BAUD
300
19200
BAUDRA1ES
OUTINT
000
3600
TIME (SECONDS)
3-9

Edgetech 2000 Series Specifications

General

Brand	Edgetech
Model	2000 Series
Category	Measuring Instruments
Language	English