Connecting the Power and Cables
1. Place EdgeMarc into install location either in a rack with PBX or on a shelf near PBX
2. Plug Power Cord into the port (circled in red) on back panel and plug other end of cord into an
electrical outlet being careful to avoid pressing the Erase Button
3. Plug ethernet cable into port (circled in blue) on rear panel and plug into LAN port on broadband
router or modem
4. Plug ethernet cable into port (circled in green) on rear panel and plug into LAN port on IP PBX or on
Prem SBC
5. Make sure that the power and status LEDs on the front panel are solid green after the EdgeMarc
powers on
6. Call 866.780.8639 to inform IntelePeer NOC device is plugged in and powered on
To Previous Page
Loading...
Need help?
General