To Next PageTo Next Page
Need help?Do you have a question about the EDI 210 Series and is the answer not in the manual?
General| Aspect Ratio | 16:9 |
|---|---|
| Brightness | 250 cd/m² |
| Color Support | 16.7 million colors |
| Resolution | 1920 x 1080 |
| Contrast Ratio | 1000:1 |
| Response Time | 5ms |
| Input Ports | VGA, HDMI |
Configures channel conflict settings and signal sensing via the Program Card.
Enables or disables the Watchdog Monitoring function using the WD ENABLE switch.
Describes the status indicators like AC Power, VDC Failed, WDT Error, Conflict, PCA, and Channel Status.
Details the front panel controls, primarily focusing on the Reset Button's functions.
Overview of the unit's architecture and core components like the MPU and RMS-Engine.
Explains the main microprocessor (MPU) and its operational modes and logic.
Describes the SPI communication protocol used by the unit's microprocessors.
Details the function and fault handling of the internal MPU Watchdog timer.
Covers the nonvolatile EEPROM memory used for storing status information.
Explains the 24VDC logic inputs, including Watchdog and reset signals.
Describes how the front panel LED display is multiplexed and controlled.
Covers the input methods for program cards and configuration switches.
Explains the function of the RMS-Engine for accurate voltage measurements.
Details the operation and specifications of the unit's power supply.
Provides systematic steps to diagnose and resolve common operational faults.
Specifies power requirements and voltage monitoring parameters.
Lists the timing characteristics for various functions like conflict and fault detection.
Provides physical dimensions of the signal monitor unit.
Specifies the operating and storage environmental conditions.
Lists pin functions for the main monitor unit connector (P6).
Lists pin functions for the program card connector (P4).
Shows a diagram of the program card with its configuration options.
