MAINTENANCE NOTE
EBERLE DESIGN INC. SIGNAL MONITORS HAVE BEEN CAREFULLY INSPECTED
AND TESTED TO ENSURE PROPER OPERATION. IT IS RECOMMENDED THAT THE
SIGNAL MONITOR BE TESTED AT LEAST ANNUALLY TO ENSURE COMPLIANCE
WITH THE PROPER SPECIFICATIONS.
- WARNING -
PIN 27 OF THE MAIN CONNECTOR (P6) PROVIDES THE CLOSED CONTACT OF
THE OUTPUT RELAY WHEN THE MONITOR IS IN THE NO-FAULT STATE. WHEN
THE MONITOR IS IN THE NO-FAULT STATE AND THE AUTO/FLASH SWITCH IS
IN THE FLASH POSITION, AC LINE VOLTAGE MAY BE PRESENT ON PIN 27.
THIS PIN WAS PREVIOUSLY DEFINED AS A “NO-CONNECT’ PIN IN LEGACY
EQUIPMENT. TO PREVENT POTENTIAL EXPOSURE TO ELECTRICAL SHOCK,
BEFORE INSTALLING THIS MONITOR THE USER IS CAUTIONED TO CHECK
THAT THE CABINET WIRING IS COMPATIBLE WITH THE USE OF THIS PIN AS A
SOURCE OF AC LINE VOLTAGE.
To Next Page
Loading...
Need help?
General