19
Appendix 2
Troubleshooting
Trouble
Symptom
Trouble Possible Solution
1 Faint LED
is permanently
ON
The recorder is
unresponsive
to the user’s
activity
Replace the battery
(for battery recorders)
Press the Reset button for
2 seconds or switch off and
then back on the recorder's
power (for rechargeable
battery recorders)
2 When
connecting
the recorder
to the PC the
LED is ashing
frequently
The recorder is
unresponsive
to the user’s
activity - the
rechargeable
battery is
discharged
Leave the recorder
connected to the PC. After
some time depending
on the battery discharge
level the PC will recognize
a removable media and
the LED will be ashing
gradually with the interval of
5 seconds.
3 No ash of
LED on the
recorder after
disconnecting
off the PC
When
disconnecting
off the PC the
recorder won't
g to Standby
Mode
Remove and install battery
again (for the recorders
with batteries). Press the
Reset button for 2-3 seconds
(for the recorders with
rechargeable batteries).
To Next Page
Loading...
