8
English
Optical/coaxial mode
• Press the "volume/input" dial on the side panel of the active speaker, or press the " OPT/COAX " button on the remote control
to switch to optical/coaxial mode, the red light will be lit.
• Connect audio source (Blu-ray player, Set Top Box, etc.) to the " OPT " / " COAX " input port on the rear panel of the active
speaker using fiber optic audio cable or coaxial audio cable (not included).
• Play music on the connected device and adjust the settings to a desired level.
Note:
In optical and coaxial modes, only PCM signal with 44.1KHz/48KHz can be decoded.
or
ON OFF
OPT/
COAX
LINE1/2
ON OFF
OPT/
COAX
RC80B
LINE1/2
To Next Page
Loading...
