9
English
Optical / Coaxial Input
1. Connect audio source (Blu-ray player, Set Top Box, etc.) to Optical/Coaxial input port on the rear panel of the active
speaker using fiber optical audio cable or coaxial cable (not included).
2. Press the “OPT”/“COAX” button on the remote control, or press the “Volume dial/Input selection” dial on the rear panel
of the active speaker, red light will be lit.
3. Play music on the connected device and adjust the settings to a desired level.
Note:
Only the standard PCM audio signals (44.1KHz/48KHz/96KHz/192KHz) function in optical/coaxial mode.
or
COAX
LINE1
LINE2
OPT
To Next Page
Loading...
