EDIFIER Tick Tock Dock User Manual

①. Press “MODE” to access the time setting;
②. Press “SET” to access sequently the hour, minute, year, month, day and
12-hour / 24-hour clock settings
③. The setting selected blinks
④. Press UP / DOWN to adjust the setting.
1. The system will show the time display if there is no operation within 30 seconds.
2. Sleep setting is the time specified for music to play before the Tick Tock Dock automatically turns to standby mode.
①. Press “MODE” to enter the sleep setting,
②. Press “SET” to enable the sleep timer, the figures of sleep timer will blink
③. Press UP / DOWN to set Sleep time (Seven settings: 15min, 30min, 45min,
60min, 75min, 90min and sleep timer off).
MinuteHour
Alarm On/Off
Morning/Afternoon
Sleep time
Time and Alarm clock setting guidance
English English
Power output: RMS 4.5W×2 (THD+N=10%, f0=1KHz)
Signal to noise ratio: ≥80 dBA
Distortion: ≤ 0.5% (@½ output)
Frequency response: 70Hz-20KHz
Input type: AUX/FM/iPod
Input sensitivity: 750 mV ± 50mV
Adjustment: Buttons on top and rear panel of speaker
Speaker unit: 1½ inch (40mm), magnetically shielded, 8ohm
Dimension: 130(W) × 126(H) × 89(D) mm
Net Weight: Approx. 0.5 kg
Gross Weight: Approx. 0.6kg
7
8
Specications
Year
Month
Alarm 1
Date
①. Press “MODE” to access the alarm setting
②. Press “SET” to access sequentially the alarm index, alarm on/off, hour,
minute, alarm source, alarm volume
③. Press UP / DOWN to adjust the setting. There are 5 available alarms.
The alarm will last 5 minutes once it is triggered, sleep time is 10 minutes.
The alarm will trigger for three times and work in this order if there’s no
operation when the alarm rings: Alarm-Snooze-Alarm-Snooze-Alarm-STBY
AM
SLEEP
Time setting
Alarm setting
Sleep setting
Note

EDIFIER Tick Tock Dock Specifications

General

Brand	EDIFIER
Model	Tick Tock Dock
Category	Docking Station
Language	English