⚫ Power On/Off
1. Power on
• Power on automatically when taken out of the charging case;
• When without charging case, press the multi-function button to power on.
2. Power off
• Power off automatically while placed in the charging case;
• When without charging case, press and hold the multi-function button for 7 seconds to power off.
⚫ Bluetooth Connection
1. Two Earbuds Mode
• Open the charging case to take two earbuds out, they will automatically turn on and make TWS
interconnection;
• Press and hold the multi-function button of the left earbud to enter pairing state, the red and blue
lights will flash rapidly;
• Set mobile phone to search and connect to this product model, after pairing is successful, the blue
light will flash slowly.
Note: the earbuds will automatically enter Bluetooth pairing mode when used for the first time.
2. One Earbud Mode
If use one earbud only, please take the left or right earbud out of the charging case, and refer to the
procedures mentioned in“Two Earbuds Mode”to pair it with mobile phone.
⚫ TWS Pairing of the Left and Right Earbuds
The left and right earbuds have finished TWS pairing before leaving factory. If the wireless
connection fails to resume, please follow the steps below to re-pair:
• When not connected with mobile phone, take two earbuds out and respectively double press the
multi-function buttons of the left and right earbuds to enter TWS pairing state, the blue lights will
flash rapidly;
• Make two earbuds close to each other, after pairing is done the blue lights of both earbuds will
flash slowly.
⚫ Clear pairing records
Place the earbuds in the charging case, respectively press and hold the multi-function buttons of the
left and right earbuds for six seconds until the blue lights flash six times rapidly, and then the pairing
records have been cleared.
To Next Page
Loading...
Need help?
General
