EDIFIER W210BT

EN 1. Power ON/OFF
2. Pairing
3. Reset
4. Controls
Wireless Neckband Headphones
W210BT
Manual
1. When they’re power o, press and hold the power button for 5s.
Green and red LED will blink rapidly.
2. Select "EDIFIER W210BT" in your device setting to connect.
1. The headphones are power on and disconnected from all devices.
2. Press and hold the " " and "v" at the same time for 5s.
3. The status light blinks green until reset is completed.
4. Once the headphones are reset, they enter pairing mode
automatically.
1st Pairing
1. Once the headphones are power on, they will enter Bluetooth
pairing automatically. Green and red LED will blink rapidly.
2. Select "EDIFIER W210BT" in your device setting to connect.
Note:
For subsequent use, the headphones will auto-connect to device
used last time.
5s
5s
Note:
1. : Press and hold
2. Images are for illustrative purposes only and may dier from the
actual product.
For more information, please visit our website:
www.edier.com
@Edier_Global @Edier_Global@Edierglobal
Model: EDF200104
Edier International Limited
P.O. Box 6264
General Post Oce
Hong Kong
www.edier.com
2023 Edier International Limited. All rights reseed.
Printed in China
NOTICE:
For the need of technical improvement and system upgrade,
information contained herein may be subject to change from time
to time without prior notice.
Products of EDIFIER will be customized for dierent applications.
Pictures and illustrations shown on this manual may be slightly
dierent from actual product. If any dierence is found, the actual
product prevails.
Press and hold the power button for 3s.
3s
Indicator
3s 5s
x1x3
x1 x1
x2x2
x1
x1

EDIFIER W210BT Specifications

General

Type	On-ear
Bluetooth Version	5.0
Charging Time	2 hours
Driver Size	40 mm
Frequency Response	20 Hz - 20 kHz
Driver	Dynamic
Impedance	32 Ω
Charging Port	Micro USB
Bluetooth	Yes
Connection	Wireless
Driver Unit	Dynamic

Summary

Power ONOFF

Power Button Operation

Press and hold the power button for 3 seconds to turn the device on or off. An indicator light is present.

Bluetooth Pairing

Initial Pairing Process

When powered off, hold the power button for 5s. Green and red LEDs blink rapidly. Select 'EDIFIER W210BT' to connect.

Automatic Reconnection

For subsequent use, headphones automatically connect to the last used device.

Factory Reset

Reset Procedure

With headphones on and disconnected, press and hold 'A' and 'v' buttons for 5s. Status light blinks green.

Post-Reset State

After reset, headphones automatically enter pairing mode.

Button Controls

Playback and Volume

Control music playback (play/pause, next/previous track) and volume levels with button presses and holds.

Call and Voice Assistant

Manage calls (answer/end) and activate voice assistant using specific button presses.

Gaming Mode

Activate low-latency gaming mode by pressing specific buttons twice.