Operating
1
2
3 Playing the audio device
CONNECTING
Connect the satellite speakers to the output RCA on the
back panel of the Sub-woofer. Please note to match the color,
red to red and white to white.
Connect the subwoofer to the Audio device.
Using Audio connecting cord , connect the Line-input port
of the subwoofer to Line-out of the Audio Device (Such as the
computer, Discman, etc).
Plug the AC power plug into the wall outlet and turn on the
power switch, Now your speaker system is ready for Use.
Adjusting the volume control and Bass control , then you can
enjoy the music.
Total Power Output : RMS 6W x 2 + 12W(THD=10%)
Input Impedance: 10K Ohm
Input Sensitive: 450 mV
Bass Unit: 5.5" Aluminum coil, 4 Ohm
Tweeter Unit: 3" Paper coil, 4 Ohm
Dimension(Subwoofer): 221(W) x 207(H) x 249(D)mm
Dimension(Satellite): 91(W) x 173(H) x 116(D)mm
Gross Weight: About 6 Kg
SPECIFICATIONS
Notice
Edifier assumes no responsibility for any errors that may appear
in this manual. Information contained herein is subject to change
without notice.
Operating
2
To Next Page
Loading...
Need help?
General
