EdilKamin IDROFLEXA - Page 13

- 13 -
ENGLISH

T
g. 1
g. 2

g. 3


You must consult the Edilkamin DEALER in your area when
igniting the boiler-stove for the rst time, in order for the
boiler-stove to be calibrated according to the type of pellets and
installation conditions, thereby validating the warranty.
There may be a slight smell of paint the rst few times it is
ignited, however, this will disappear quickly.
Before igniting you must check:
==> that installation is correct
==> the power supply
==> that the door closes properly to a perfect seal
==> that the combustion chamber is clean
==> that the display is on standby
(time and temperature)

Remove the bayonet-xed upper grille and adjust
the alignment of the external door with the ceramic or alumi-
nium sides, using the screws V (g. 1).

To access the hopper, lift up the cast iron top (g. 2).
ATTENTION:









IDROFLEXA is designed and programmed to burn wood pel-
lets with 6 mm diameter. Pellets are a type of fuel in the form
of little cylinders, made from compacted sawdust, compressed
under high pressure with no adhesives or foreign materials.
They are sold in bags of 15 kg.
For the boiler-stove to function properly, you MUST NOT
burn anything else in it. Using other materials (including
wood) will render the warranty null and void. Such use is
detected by laboratory analyses.
Edilkamin has designed, tested and programmed their boiler-
stoves to guarantee the best performance when pellets with
the following characteristics are used:




If pellets with different characteristics are used, the boiler-
stoves must be recalibrated – a similar procedure to that carried
out by the
DEALER when the boiler-stove is ignited the rst time.
Using unsuitable pellets may: decrease efciency; cause
malfunctions; stop the boiler-stove from functioning due to
clogging, dirt on the glass, unburnt fuel, etc.
A simple, visual analysis of the pellets may be carried out:
 smooth, uniform length, not very dusty.
with longitudinal and transverse cracks, very
dusty, various lengths and mixed with foreign matter.