Edimax 16 Port Nway Fast Ethernet PoE Web Smart Switch - Page 10

- 9 -
Port Management: Port Configuration
Select the “Port No.” - configure the mode below:
1. “Auto-Nego” - enable/disable Auto-Negotiation.
2. “Speed” - 10M or 100M mode for the selected port.
3. “Duplex” - Full or Half-Duplex mode for the selected port.
4. “Pause” - enable/disable for the selected port.
5. “Backpressure” - enable/disable for the selected port.
6. “Tx Cap (Capability) ” - enable/disable for the selected port.
7. “Addr. Learning” - enable/disable for the selected port.
Now, the setting of “Port Configuration” is finished.