protocol will be dropped and other protocols will be
forwarded.
“Allow”: the selected protocol will be forwarded and other
protocol will be dropped.
2. “Secure Port” – choose secure ports which you want.
**Note 1:
a. The secure WAN port should be set at the physical port
which is connected to the server.
b. Once this function is enabled, the switch will check the
destination TCP/UTP port number at the outgoing direction
of the secure WAN port.
If the condition matches, this packet will be dropped or
forwarded.
**Note 2: The description of Secure WAN port is shown on the
bottom of this screen.
3. “Protocol” – choose protocols which you want.
4. Click “Update” to confirm and finish the setting.
Now, the setting of “TCP/UDP Filter Configuration” is finished.
To Next Page
Loading...
