Need help?Do you have a question about the Edimax ES-5808P and is the answer not in the manual?
General| Ports | 8 |
|---|---|
| PoE Ports | 8 |
| PoE Budget | 130W |
| Switching Capacity | 16Gbps |
| MAC Address Table | 1K |
| Power Supply | Internal |
| Power Input | 100-240V AC, 50/60Hz |
| Forwarding Rate | 11.9 Mpps |
| Dimensions | 44 mm |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -40°C to 70°C |
| Humidity | 10% to 90% (non-condensing) |
Allows users to set or change the administrator username and password for the switch.
Enables configuration of the switch's IP address, subnet mask, and gateway.
Details updating firmware via the web interface or using a TFTP client.
Allows setting and viewing operation modes for each port, including speed, duplex, and auto-negotiation.
Provides detailed settings for PoE ports, including enable/disable status and PSE current.
Allows users to view and control power output status for each PoE-enabled port.
Allows selection between Port-based and Tag-based VLAN modes for traffic segmentation.
Assigns ports to VLAN groups, differing between Port Based and Tag Based modes.
Sets packet prioritization modes: FIFO, All-High-Before-Low, and Weighted-Round-Robin (WRR).
Maps applications (TCP/UDP, IP TOS/DS, 802.1p) to priority queues for traffic management.
Allows binding specific MAC addresses to ports to enhance security and control access.
To Next Page
