*How to use the Wi-Fi Detector:
1. Slide the power switch to the “ON” position, and a welcome
screen will greet the user.
2. After the welcome screen is displayed the Wi-Fi detector will
automatically enter scanning mode to detect Wi-Fi signals.
In scanning mode the LCM will display the total number of
both non-encrypted and encrypted Wi-Fi signals detected.
3. Once scanning mode is complete, the detector will enter its
standard display mode.
The detector automatically sorts the signals by the following
criteria: Non-encrypted AP’s according to signal strength
followed by encrypted AP’s according to signal strength.
To Next Page
Loading...
Need help?
General