51
Getting connected and installing drivers (Macintosh)
4
Verify the installation location, and click [Install].
fig.3-2_40
5
If a message like the following is
displayed, click [Continue].
The other currently running
applications will exit, and
installation will continue.
6
A dialog box will indicate Installation completed.
Click [Restart] to restart your Macintosh.
OMS settings
1
From the CD-ROM, drag the Driver-OMS Driver-OMS Settings folder to
the hard disk of your Macintosh to copy it.
fig.3-4
2
In the Opcode-OMS Application folder where you
installed OMS, double-click OMS Setup to start it up.
fig.3-5_35
3
If a dialog box like the one shown
here appears, click [Turn It Off]. A
confirmation dialog box will then
appear, so click [OK].
fig.3-6_35
4
The Create New Setup dialog box will
appear.
Click [Cancel]. If you accidentally
clicked [OK], click [Cancel] in the next
screen.
To Next Page
Loading...
