A419-00-880 Issue F
Page 12 © Edwards Limited 2007. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Introduction
Figure 7 - End User Controller (EUC) display
1.5 Connections
Refer to Table 2 and Figure 4.
1.6 Control and monitoring
The EPX L and N series of pumps cannot be manually operated; they must be controlled and monitored by external
control equipment, which must be connected to the EPX pump through the TIM (Figure 2, item 5).
The EPX E series of pumps can be manually operated using the EUC local display and keypad, or remotely using a PDT,
if fitted; it can also be controlled and monitored over the network, which connects to the EPX pump through the
Network connector (Figure 5, item 2). When the EPX ‘E’ series of pumps is controlled via the TIM, the EUC simply
monitors the status of the pump.
The EPX pump is compatible with Fabworks 32.
1.7 EPX pump labels
Refer to Table 3 and Figure 4.
1. Run button
2. Display
3. Down button
4. CANCEL button
5. Up button
6. ENTER button
7. Menu buttons Status, Normal, Control, Setup
8. Menu selected LEDs
9. Status LEDs Local Control, Warning, Alarm
10. Stop button
To Next Page
Loading...