Need help?Do you have a question about the Edwards iXH100 and is the answer not in the manual?
General| Brand | Edwards |
|---|---|
| Model | iXH100 |
| Category | Water Pump |
| Language | English |
Describes the intended uses of iXH, iXL, and pXH pumping systems in various industries.
Details the features and benefits of the iXH dry pump range and the iXL pump range.
Explains how system control is managed by different modules and prioritizes control requests.
Provides physical dimensions, mass, noise levels, and flange specifications for various pump models.
Details typical pumping speeds, ultimate vacuum levels, and maximum continuous inlet pressures for each pump.
Outlines motor ratings, current ratings, fuse requirements, and cable specifications for system power connections.
Specifies water supply pressure, temperature range, and material compatibility for system cooling.
Provides instructions for positioning the pump, including lifting and levelling procedures.
Details how to connect the pump inlet and exhaust to the vacuum and extraction systems.
Covers essential safety requirements and connections for the system's electrical power supply.
Explains the procedure for safely connecting the power cable using specified connectors.
Guides on connecting the cooling water supply and setting the correct flow rate.
Outlines the steps to verify system connections and start up the pumping system.
Describes the procedures for powering on and initiating the pumping system operation.
Details methods for safely stopping the pump, including auto and fast shut-down modes.
Explains system protection sensors, warnings, and conditions that trigger alarms.
Covers the function of the emergency stop button and its effect on system operation.
Highlights safety precautions and recommended intervals for performing maintenance tasks.
Provides instructions on how to safely move the system for servicing or repair.
Details the procedure for removing cooling water from the system before transport or storage.
Covers routine visual inspections and checks for system components and connections.
Explains how to adjust operational modes for gas modules based on process demands.
Outlines procedures and precautions for safely shipping the pumping system.
Provides guidance on safely disposing of the system and its components according to regulations.
Details how to access Edwards service centres for support, repair, and maintenance.
Lists available accessories and provides information on how to order them.
Explains how to start, stop, and control the pump using the Pump Display Terminal (PDT).
Describes how warnings and alarms are displayed and acknowledged via the PDT.
Outlines the navigation structure and available menus on the Pump Display Terminal.
Lists common warning messages displayed by the pump controller and their potential causes.
Details alarm messages, possible causes, and recommended actions for system issues.
Explains inverter-specific fault codes, warnings, and alarms for pump and booster systems.
Covers troubleshooting for issues like pump controller communication failures.
To Next Page
