EEC EGS Series - Page 5

4
EGS Series Quick Start User Manual
Version 01 - 2020
Handling
The EGS Series soft starter range comprises 3 frame sizes, with various weights and dimensions. See pages 5-7
for further information.
Prior to installing the EGS unit, the installer should carry-out a risk assessment. If considered appropriate, a
suitable handling device should be used.
Do not lift the EGS Soft Start unit by attachment to the 3-phase terminal connections or busbars.
WARNING
HANDLING AND LIFTING HAZARD
Ensure the area below any equipment is clear of all personnel and property.
Failure to follow this practice may result in death, serious injury, or damage to equipment.
Accessories
The following accessories have been developed and tested for use with the EGS Soft Start range of soft starts:
EGS-RKP Remote keypad for EGS-017A to EGS-361A. Provides remote functionality for up to 32 soft starter units.
EGS-ACU 100Vac – 240Vac power supply. Provides mains voltage control power and digital control functionality.
For use with EGS-017A to EGS-361A.
EGS-FS1 Cooling fan accessory for EGS-017A to EGS-065A only. Increases the number of starts per hour (see
page 19).
EGS-FS2 Cooling fan accessory for EGS-080A to EGS-195A only. Increases the number of starts per hour (see
page 19).
Installation (continued)