13
operate the SE through simple PLC relay control.
Allows the operator to self-verify the instrument’s
failure detectors.
Allows the operator to set multiple dwell cycles at
different voltages for ACW/DCW/IR so that test
voltages can be raised and held in steps
Connect a barcode scanner directly to the instrument
front panel and perform the appropriate tests.
Transfer test data directly to a USB flash drive after
performing the test.
*Pro Volt Operational Rules
1. Provolt will only link tests of the same type.
2. If the previous step voltage is higher than next step voltage, it will ignore ramp up of next step.
3. If the previous step voltage is lower than next voltage, it will ignore ramp down of previous step.
4. Frequency changes in ACW are not allowed. If a test sequence has been created with frequency changes and the
system is set to provolt and you attempt to run the file, it will warn you that there are frequency changes in the
file and prevent the operation.
To Next Page
Loading...
