eeese Carl - Error Code Reference

96
MV-2506-01-2023
.
eeese-aircare.com © All rights reserved by eeese air care ApS
UK
7. Storage
If the unit will not be used for an extended period, do the following:
1. Unplug the unit.
2. Clean the air lter with a vacuum cleaner.
3. Make sure the device is in perfect condition so that it is safe to use again after a long
storage period.
4. Store the unit in appropriate packaging.
5. Store the unit in a dust-free place and out of direct sunlight. It is recommended to
cover it with a piece of plastic.
8. Display Error Codes
Please contact your local distributor if any of the error codes below appears.
No. Display
code
Error Display Observation
1 E1
Temperature
sensor error
Flashs every
30 seconds
Dehumidier works normally.
2 E2
Humidity
sensor error
Flashs every
30 seconds
Dehumidier works normally, but can’t
set the humidity.
3 L3
Air inlet
temperature
is too high
≥42ºC
Slow ash L3
Compressor stops working, fan works
at low fan speed.
If the dehumidier temperature decreas-
es below 40ºC, the dehumidier will
start working normally.
5 L4
Air inlet
temperature
is too
low ≤0ºC
Slow ash L4
Compressor stops working, fan works
at low fan speed.
If the dehumidier temperature increas-
es above 2ºC, the dehumidier will start
working normally.