en
WARNING: Only use cutting attachments with the
guards we recommend! See the chapter on
Recommended cutting attac
hments (Page 10). Refer
to the instructions for the cutting attachment to
check the correct way to load the cord and the
correct cord diameter. Keep the teeth of the blade
correctly sharpened! Follow our recommendations.
Also refer to the instructions on the blade packaging.
Maintain the correct blade setting! Follow our
instructions.
WARNING: Always stop the engine before doing any
work on the cutting attachment. The attachment
continues to rotate even after the throttle has been
released. Ensure that the cutting attachment has
stopped completely and disconnect the HT lead from
the spark plug before you start to work on it.
WARNING: Using an incorrect cutting attachment or
an incorrectly sharpened blade increases the risk of
kickout.
WARNING: Always discard a blade that is bent,
twisted, cracked, broken or damaged in any other
way (Fig.20, page 13). Never attempt to straighten a
twisted blade so that it can be reused. Only use
original blades of the specified type.
WARNING: To reduce the risk of serious injury, never
use wire or metal-reinforced line or other material in
place of the nylon cutting lines. Pieces of wire could
break off and be thrown at high speed toward the
operator or bystanders.
Fitting the trimmer head (Fig.21)
Put the upper (A) flange in place. Push the head fixing button (B)
and tighten the head (C) counter-clockwise by hand.
Fitting the blade (Fig.22)
Loosen the nut (A) clockwise; remove cup (B) and lower flange
(C). fix the blade (D) onto the upper flange (F) making sure that
the rotation direction is correct. Fix the lower flange (C), the cup
(B) and tighten nut (A) counter-clockwise. Push the button (F) to
block the blade and allow the nut (A) to be tightened to 22 ftlb (30
Nm).
WARNING: Arrows on the cutting attachment guard
(Fig.23) show the correct direction of rotation of the
cutting tool.
WARNING: Fit the blade protection (M) p.n. 4196086
as shown (Fig.24-25) before transporting or storing
the brush cutter.
CAUTION: Never use the brush cutter without the cup
(B, Fig.22) to avoid damages to the thread.
14
ASSEMBLY
21
22
23
24
25
To Next Page
Loading...
