Efco TR 1551 - MAINTENANCE; Maintenance Chart

en
19
MAINTENANCE
Maintenance Chart
Please note that the following maintenance intervals apply for normal operating conditions only. If
your daily work requires longer than normal or harsh cutting conditions are present the suggested
intervals should be shortened accordingly.
Before Each
Use
After Each
Refueling Stop
After Finishing
Daily Work
Weekly
Monthly
If Damaged or
Faulty
As Required
Complete Machine Inspect (Leaks, Cracks, and Wear)
XX
Clean
X
Controls (Ignition Switch, Choke Lever, Throttle
Trigger, Trigger Interlock)
Check Operation
XX
Fuel Tank Inspect (Leaks, Cracks, and Wear)
XX
Clean
X
Grease Cap Inspect (Leaks, Cracks, and Wear)
XX
Clean
X
Fuel Filter Inspect
X
Clean, Replace Filter Element
X
Every 6
Months
Bit Inspect (Damage, Sharpness, and Wear)
XX
Sharpen
XX
Clutch Drum Inspect (Damage, and Wear)
X
Replace
X
All Accessible Screws and Nuts (Not Adjusting
Screws)
Inspect
X
Retighten
X
Air Filter Clean
XX
Replace
X
Every 6
Months
Cylinder Fins Clean
X
Starter System Vents Clean
X
Starter Rope Inspect (Damage and Wear)
X
Replace
X
Carburetor Check ldle (Chain must not rotate at ldle)
XX
Spark Plug Check Electrode Gap
X
Replace
X
Every 6
Months