2. Install the sensor(s) and transmitter
__________________________________________________________
9
EFERGY RECOMMENDS THAT INSTALLATION IS
CARRIED OUT BY A QUALIFIED ELECTRICIAN
Place the sensors around the
feed wires of your electric panel.
Pull the clasp to open the
sensor, place it around the feed
cable and push the clasp to
shut.
Efergy recommends high
quality alkaline or lithium batteries
for the best product performance.
Battery life will depend on
environment (up to 12 months).
Insert the sensors jack into the
base of the transmitter.
Make sure you insert the
sensor(s) jack first, then power
on the Transmitter.
Open the Transmitter case and
insert three AA batteries (not
provided).
Mount the transmitter on the wall
next to or above the electric
panel.
To Next Page
Loading...
Need help?
General